DarkBlizz

Quote from: ptanhkhoa on June 20, 2010, 01:29:46 AM
Put this "ai" folder in All in One folder (overwrite the old one ), need to use on the official maps.

You're my hero, worked like a charm <3

Quote from: Chriamon on June 19, 2010, 07:51:43 PM

Quote from: soclever on June 19, 2010, 05:26:45 PM
First off I'd like to thank you for putting in the time and effort to make an AI.  That being said, I can't make it work >_< the AI acts like it's going to do something at the start, goes to about 10 workers on any race, makes a building or two, then stops production of everything.  I sat an overlord over its base, it went to 10 workers, had a gas/gate/cyber, then didn't do anything but mine for about 5 minutes.  After that it moved every single worker to the 1 gas node, made a single chrono'd zealot and attacked.  10 minutes later it did the same thing with a single stalker.  I didn't make any attacks at its base, just watched for a while.  I've tried launching with both sc2allin 9.6.6 and sc2launcher 2.3.1.  I've also tried vers .47 of both green and darktea, and just tried it again with .47d.  I know the AI can do better then this by just reading the comments you've been getting on it, just can't figure out why mine won't.   If it makes a difference, the starcrack AI 6.1.1 works fine for me, but I heard yours was the best.  Please help!

That sounds like the behavior of the default AI. You probably didn't install the AIs correctly, and were just launching your maps with default AI.

That's what I was thinking too but the starcrack AI works just fine in both launchers and I followed all the directions in the OP

First off I'd like to thank you for putting in the time and effort to make an AI.  That being said, I can't make it work >_< the AI acts like it's going to do something at the start, goes to about 10 workers on any race, makes a building or two, then stops production of everything.  I sat an overlord over its base, it went to 10 workers, had a gas/gate/cyber, then didn't do anything but mine for about 5 minutes.  After that it moved every single worker to the 1 gas node, made a single chrono'd zealot and attacked.  10 minutes later it did the same thing with a single stalker.  I didn't make any attacks at its base, just watched for a while.  I've tried launching with both sc2allin 9.6.6 and sc2launcher 2.3.1.  I've also tried vers .47 of both green and darktea, and just tried it again with .47d.  I know the AI can do better then this by just reading the comments you've been getting on it, just can't figure out why mine won't.   If it makes a difference, the starcrack AI 6.1.1 works fine for me, but I heard yours was the best.  Please help!